Avid Technology SR2400, Руководство по установке, Страница: 67 / 90

Using the ping and tracert Commands
67
The ping result should resemble the following:
Reply from 192.168.10.5: bytes=32 time<10ms TTL=255
Reply from 192.168.10.5: bytes=32 time<10ms TTL=255
Reply from 192.168.10.5: bytes=32 time<10ms TTL=255
Reply from 192.168.10.5: bytes=32 time<10ms TTL=255
Four responses of "Reply from…" indicate the network is configured
correctly and the originating and destination hosts can see each other on
the network.
If any one of the responses in the ping result says:
Request timed out.
or
Destination host unreachable.
it indicates the network is not configured correctly or there are other
network problems. Some items that can cause network problems are:
• Bad, loose, or incorrectly connected cables
• An incorrectly configured IP address or subnet mask on a local or
remote system
• Excessive network traffic
tracert
While ping can test for connectivity between two network hosts, tracert (short
for “trace route”) can verify the network path that the data uses to travel
between the two hosts.
Because Avid Composer Products applications are data intensive, it is
important that large amounts of data be transferred between the PortServer
system and its clients in a timely fashion. An incorrectly configured network
might get the data to its destination, but be too slow for your application to
work effectively.
You can use the tracert command to confirm that the data is traveling along an
optimal path. In a PortServer Pro workgroup, the PortServer system and its
clients should send traffic directly to each other. Routers should not be used to
direct traffic between them.