Avid Technology Milan MLN-192, Руководство по установке

Страница: 9 / 16

MLN-192 Option Card Installation 9
To install the MLN-192 card into AVB Network slot 3:
1
Hold the card it by its edges.
2
Inside the unit, place the face of the card into position in the
slot, with the back of the card tilting upwards. Make sure the
card does not make contact with the AVB-192 card below it.
3
Using two hands, hold the front of the card in place in the slot
with one hand, and slowly move the back of the card down-
wards along the sheet metal until the card is horizontal.
4
Once the card is horizontal, make sure the tab on the right side
of the faceplate is outside of the E6L chassis slot.
5
Align the PCIe connector on the card with the corresponding
PCIe port, and align the flange on the card with the retaining
clip on the PC board.
6
Lift the tab on the retaining clip, and then press the card firmly
into the PCIe port and clip.
7
When the card is properly seated in the slot, tighten the exte-
rior captive thumbscrew to secure the faceplate of the card to
the back panel of the E6L.
8
Tighten the rear bracket captive thumbscrew to secure the
back of the MLN-192 card to the back bracket.
9
Proceed to “Re-install the E6L Engine Core” on page 12.
Re-Install the AVB-192 Cards
E6L-192 and E6L-144 Only
After installing a MLN-192 card into an E6L-192 or E6L-144,
re-install AVB-192 Network Card(s).
To re-install the Master AVB-192 card:
1
Pre-position the red and black AVB power cable: it must be be-
low where you will be installing the Master AVB-192 card and
above the MLN-192 card (and WSG-HD card, if any).
2
Place the face of the card into position in its slot (the lowest
slot 1/Master AVB slot) with the back of the card tilting up-
wards.
3
Slowly move the back of the card downwards along the sheet
metal until the card is horizontal.
4
Once the card is horizontal, make sure the tab on the faceplate
of the Network card is positioned on the outside of the slot.
5
Align the PCIe connector on the card with the corresponding
PCIe port, and align the flange on the card with the retaining
clip on the PC board.
Figure 36. Lifting the tab on the retaining clip
Figure 37. Securing the card to the back bracket
Figure 38. AVB power cable pre-positioned
Figure 39. Lowering the AVB-192 card into position while keeping the
power cable clear