54
Transferring Disk Drives or Stripe Sets from the Windows NT
System to the Windows 2000 System
The following list provides an overview of this section on how to
transfer LVD shuttles from an existing Windows NT system to a
Windows 2000 system using the disk configuration floppy disk. The
sections that follow the bulleted list provide step-by-step procedures.
•
Create a disk configuration floppy disk if you have not already
done so, as described in the previous section.
•
Make sure both systems are properly shut down and you move
the disk drives to the Windows 2000 system.
•
Make sure you have installed the latest drivers for the disk
controller board on the Windows 2000 system before you move
drives or stripe sets.
•
Determine the drive numbering (SCSI IDs) of the disk drives on
the Windows NT system and maintain the same SCSI IDs on the
Windows 2000 system. You might need to change the SCSI IDs of
existing drives on the Windows 2000 system.
•
Make sure there are no SCSI ID conflicts.
•
Make sure the termination is set properly after you move the
drives or stripe sets.
•
Have all disk drives properly connected and turned on prior to
turning on the Windows 2000 system.
Содержание MediaDock 2 Plus
Страница 1: ...a Avid MediaDock 2 Setup and User s Guide...
