Avid Technology MediaDock 2 Plus, Руководство по установке и эксплуатации

Страница: 25 / 88

25
SCSI Requirements
The MediaDock 2+ enclosure operates in a single-bus configuration.
Your Avid system identifies the LVD shuttles connected on the SCSI
bus by the assigned SCSI ID. When you are assigning SCSI IDs to the
drives, remember the following:
• Each SCSI ID on a SCSI bus must be unique.
• Each device on each SCSI bus, including the system SCSI
accelerator board, has its own SCSI ID.
• SCSI ID 7 is reserved for each SCSI accelerator board in your
system. You must never assign SCSI ID 7 to an LVD shuttle.
n
Mixing LVD shuttles with single-ended or narrow drives on the SCSI bus is
not supported.
• Wide SCSI devices, such as the LVD shuttles, can use SCSI IDs 0
through 6 and 8 through 15.
For more information, see “Determining SCSI IDs” on page 34 .
c
When you add a new MediaDock 2+ enclosure to your system,
always check which SCSI IDs are currently in use. Assigning
duplicate SCSI IDs causes problems such as system errors, the drive
not appearing on the desktop, multiple copies of the same drive
appearing on the desktop, possible data corruption, or system
startup failures.
Always make sure the drive is powered off before changing the
SCSI IDs.