Avid Technology MediaCentral Command, Руководство по установке и настройке, Страница: 180 / 194

Wiring for IOLAN to Video Server
180
11. Click the Settings button to change the Client-Initiated Connection settings accordingly:
a. Confirm that Connect at system startup is not selected.
b. Select Close TCP connection when COM port is closed.
c. Select Delay close of TCP connection, and set it to two (2) seconds.
d. In the Connection Options section, select Number of retries and set it to one (1).
e. Set the Time between connection retries to three (3) seconds.
f. Deselect Restore a dropped connection.
g. Click OK.
12. Click the Advanced tab and confirm the following options are set accordingly:
- Return when connection is fully establish should be selected.
- The maximum wait time should be set to five (5) seconds.
- Send keep alive packets should not be selected.
13. Click the Packet Forwarding tab, select Enable Packet Forwarding, and set the Idle Time to 10
milliseconds.
14. Click the Copy Settings To button and copy the settings to the remaining COM ports.
15. Click OK to save and exit. You might be asked to restart the computer.
After you have completed these steps, you can proceed with wiring serial cables between the
video device and the IOLAN server, and configure the Avid Video device service for serial
connection.
Wiring for IOLAN to Video Server
The following illustration shows the wiring diagram for the RJ45 cable.
The following illustration is the wiring diagram for the IOLAN server to video device.