Avid Technology MediaCentral Command, Руководство по установке и настройке

Страница: 179 / 194

Configuring the TruePort Clients
179
9. Confirm the following settings in the Configuration section:
a. Network, IP Settings, IPv4 Settings: Confirm that the IP address, subnet mask, and default
gateway are correct.
b. Serial, Serial Ports: Confirm that the serial ports are all enabled and that the listening ports
are 10001 through 10008. Click the Edit button to continue.
c. In the Serial Port 1 Settings dialog box, confirm that Listen for connection is selected and
that the TCP port is 10001.
d. On the Advanced tab, confirm that the Enable TCP Keep Alive box is selected.
e. On the Hardware tab, confirm that Enable line termination is selected.
f. On the Packet Forwarding tab, confirm that Prevent Message Fragmentation is selected, and
the delay is set to 10 milliseconds.
g. Serial, Advanced: Confirm that the Monitor Connections section has the following set:
- Status Interval: 5
- Retry Interval: 2
- Retry: 3
h. If any changes were needed, click OK and then click Copy to set all of the other ports to the
same settings.
10. If any changes were needed, click Download All Changes.
11. If any changes were needed, click Tools > Reset > Reboot IOLAN.
Configuring the TruePort Clients
After you complete configuration on the IOLAN server, you need to configure the TruePort clients.
To configure TruePort clients:
1. Run the TruePort Management Tool.
2. Click the Add button.
3. In the Add TruePort Adapter Wizard dialog box, enter the IP address for the IOLAN server and
click Next.
4. Add the number of serial ports corresponding to your server (such as 2, 4, 8, or 16), and choose a
starting COM port.
n
Avid recommends you choose 50 as the starting COM port, so that it is clear that you are using the
serial-to-IP ports.
5. Click Next and then Finish to save changes.
6. From the TruePort Management Tool’s main window, click Properties to configure the ports.
7. On the Configuration tab, click Settings.
8. In the Perle TruePort Adapter Setting dialog box, confirm that the listening ports match the ones
configured on the server: 10001 - 10008.
9. On the Connection tab, set Connection Mode to Full Mode.
10. Select Initiate connection to device server, and then confirm that the TCP port is 10001.