Installing AirSpeed Multi Stream in a Rack
51
Rack-mount Kit Contents
The rack-mount kit contains the following:
•
2 – rear rack support brackets (right and left)
•
2 – plastic rack ear covers
•
2 – plastic rack ear cover clips (attached to the rack ears on the chassis)
•
8 – #10-32 screws (2 for each corner)
•
8 – rack-nut clips
•
Avid service ID card (one label is affixed to the top of the AirSpeed Multi Stream
chassis)
n
Use your own rack hardware if your rack has threaded holes or unique fasteners.
Positioning the AirSpeed Multi Stream in the Rack
The following procedure helps you decide where to install the AirSpeed Multi Stream in the
rack. If your rack enclosure does not have threaded holes, install the rack-nut clips included
with the rack-mount kit where the AirSpeed Multi Stream front panel secures to the rack
enclosure. If your rack enclosure has threaded holes, do not attach the rack-nut clips.
Содержание AirSpeed series
