Avery Weigh-Tronix FLI 225, Руководство по обслуживанию

Страница: 100 / 110

100 FLSC 05 w/FLI 225 Instrument Service Manual
10.8 SMA Protocol
The following table shows the SMA communication commands supported and the
corresponding results. Refer to www.scalemanufacturers.org for complete details.
Table 10.3 SMA protocol
Command Sent to Indicator Result
<LF>W<CR> Weight returned if no motion. Dashes displayed if motion on scale.
<LF>P<CR> Weight returned if no motion. Dashes displayed if motion on scale.
<LF>Z<CR> Scale zeros itself if no motion. Dashes displayed if motion on scale.
<LF>T<CR> Scale tares itself and returns G or N weight if no motion. Dashes displayed if motion on scale.
<LF>T<xxxxxx.xxx><CR> Scale attempts to take the <xxxxxx.xxx> data as the tare weight and returns G or N weight if no
motion. Dashes displayed if motion on scale.
<LF>M<CR> Returns the tare weight if no motion. Dashes displayed if motion on scale.
<LF>C<CR> Clears the tare weight if no motion. Dashes displayed if motion on scale.
<LF>U<uuu><CR> Sets the unit of measure label to uuu Example: lb_ ( _ =space) Works for lb or kg only, not
custom units
<LF>D<CR> Runs scale diagnostics and sends diagnostic message
<LF>A<CR> Sends the SMA compliance level. See note at left.
<LF>B<CR> 1st B sent returns manufacturer
2nd B sent returns model software #
3rd B sent returns the software revision level
4th B sends an END
5th or more sends a ?
<LF>U<CR> Toggles the units of measure if no motion. Dashes displayed if motion on scale.
<LF>I<CR> Sends the SMA compliance level as SMA:compliance level / revision level