Monarch
®
1103
®
-1110
®
Labelers
Operating Instructions
TC1000OI Rev. DF 1/08 ©2007 Paxar Americas, Inc. a subsidiary of
Avery Dennison Corp. All rights reserved.
LOADING LABELS & SETTING PRINT BANDS
LOADING LABELS
1
If labeler has no label guide: Snap
label roll between hubs. Tear off
and discard first twelve labels and
backing paper.
2
Squeeze and hold
operating lever half way,
and feed label strip under brake
wheels.
3
Continue feeding label
strip until about twelve
labels come out here. Release
operating lever.
4
a
. Feed label strip up under
plate until two labels come
out here.
5
Grasp label strip and pull
briskly toward operating
lever,
6
Tear backing paper as
shown.
7
Completely squeeze operating
lever, exposing feedwheel.
Insert backing paper into slot. When
paper bows up, maintain finger
pressure and release operating
lever.
8
Squeeze operating lever
several times until backing
paper exits labeler. If backing
paper does not become taut and
exit at rear, remove backing
paper from slot and repeat steps
6 and 7.
SETTING PRINT BANDS
1
Pull knob until indicators point to
desired band.
2
Turn knob until indicators point
to desired character or blank.
3
Set all bands and push
knob in all the way.
n
Make sure the character you
select is not a print character
(UPSIDE DOWN). You
should be able to read the
character correctly through
the band window.
INKING
1
Turn latch to release ink roll
door and carefully pull it
completely out of labeler.
2
Fold a piece of scrap backing
paper.
3
Insert folded backing paper
between ink roll and
carrier. Pull to snap old ink roll
free.
4
Cut off end of new ink roll
pouch. Using pouch to protect
fingers, slide carrier into pouch and
snap new ink roll into carrier (one side
at a time).
5
Insert ink roll into ink door
opening. Tilt ink door
and press in . . .
6
Latch ink roll door securely.
Hang for
easy reference.
INKING
Brake
Wheel
Loop
Plate
b
. Squeeze operating
lever halfway and rewind
label roll until loop is
removed.
separating
labels
from
backing
paper.
Discard
separated
labels.
Straight tear
between I-cuts
Backing paper
without labels
Slot
Feedwheel
Indicators
Ink Roll Door
Latch
Lip
to place
hinge tab
under lip.
Operating
Lever
Guide Slot
Label Guide
â
If labeler has label guide: Snap
label roll between hubs. Tear off
and discard first twelve labels and
backing paper. Then, insert label
strip into guide slot as shown.
