3
English
Deutsch
Français
Italiano
Es
pa
ñol
Č
esky
M
M
a
a
k
k
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
s
s
The ports on the rear, left and right panel of enable you to connect the unit to a
computer, graphics display monitor or LCD/DLP projector, TV or other device. Illustrated
below are the ports that are located at the rear and right panel of with their
corresponding labels.
Rear Panel
(1) (2)
(3)
(4)
RS-232
DC 12V
RGB IN 2
RGB IN 1
RGB OUT
IOIOI
Name
Function
(1) DC 12V
: Connect the power adapter into this port.
(2) RS-232
: Receive command from the computer to operate
. Connect this port to the RS-232 port of the
computer.
(3) RGB IN 1 & RGB
IN 2
: Takes as input the signal from a computer or other
sources and pass it through to the RGB Output and DVI-I
port only.
Connect this port to the VGA output port of the computer.
(4) RGB OUT
: Output the signal from the camera, RGB IN port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector.
Left Panel
(1) (2) (3) (4) (5)
SD CARD
USB
DVI-I OUT
CVBS OUT
S-VIDEO OUT
Name
Function
1. S-VIDEO OUT
: Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
2. CVBS OUT
(RCA/Composite)
: Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
3. DVI-I OUT
: Output the signal from the camera, RGB IN 1/2 port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector with DVI-I interface. If the
display device does not support DVI-I, it can only display
the signal from the camera and the captured images.
The1920 X1080 resolution for DVI-I support reduced
blanking only.
4. USB
: Use as a USB Camera or Mass Storage to
transfer the captured images from memory
source to PC.
5. SD card slot
: Insert the SD card with the label facing up. It can support
16MB~2GB card capacity and only accepts FAT16
formatted card.