Avere FXT 5000 Series, Руководство по обслуживанию на месте

Страница: 7 / 48

CHAPTER
TWO
PRECAUTIONS FOR PRODUCT SERVICE AND USE
This section discusses considerations you must take before installing, using, or servicing FXT 5000 Series edge fil-
ers.
2.1 Unpacking and Handling FXT Equipment
To prevent damage to the edge filer or components, carefully unpack and handle the FXT Series edge filer and com-
ponents.
Inspect the boxes that the edge filer or component was shipped in and note whether there is any damage. If the ship-
ment shows evidence of damage, file a damage claim with the carrier that delivered it.
2.2 Restricted Access
The FXT Series edge filer nodes must be installed in a restricted-access location. A restricted-access location is de-
fined as a location that can be accessed only by use of a tool, lock and key, or other means of security and is con-
trolled by the authority responsible for the location. Anyone entering the restricted-access location, or installing or
replacing modules in an FXT Series node, must be trained in the potential hazards associated with the FXT Series
node, including but not limited to exposure to hazardous energy levels when the cover is removed, when modules
have been removed, or when modules are being replaced.
2.3 Preventing Condensation
Condensation can occur when exposing a colder product to a warmer and/or more humid environment.
If an item has been moved from an environment that is colder and less humid than the current installation and oper-
ating environment, allow it to reach the same temperature as the current environment before unpacking it, and before
installing it or powering it on.
If you notice condensation on any part of the item, Avere Systems recommends waiting a minimum of 24 hours for it
to acclimate before installation and use.
3