133
5.8
Relay Setting
The I/O device must be installed to use this function.
1. Click the drop-down list and select the relay ID number.
2. Mark
Enable
to enable the selected relay. If user wants to apply the setting to all relays, click
Apply to all
button after complete the setting of the relay.
3. Click
External IO
to configure external I/O device if it is available (see also
).
When external I/O is set and it will be available in drag down list for selecting.
4. The system automatically detects the card and input number. User can enter a short
description for this relay in
Description
frame.
5. In the test section, click
Test
to trigger relay.
Red
is high and
Green
is low.
6. Mark
Enable Pulse trigger
the relay will be triggered depends setting
of
Interval Time
and
Retrieve Time
.
Interval Time
is a time gap for the relay will be triggered, for example: the
relay will be triggered every 3 seconds if interval time is set to 3 seconds.
Retrieve Time
is the
time that relay is staying in trigger status, for example: when relay has been triggered and it
will continuous in trigger status for 2 second if retrieve time is set to 2 seconds.
7. Click
OK
to exit and accept the setting and
Cancel
to exit without saving the setting.
Содержание IWH5000 Series
