2.4.3
FRONT PANEL (Receiver/Decoder, HDM-C6MWIP-R-V3)
1.
Power LED: Indicates if the unit is powered OFF or ON by a RED LED.
2.
Status LED: Steady Blue Light ON indicates Decoder is connected to an encoder and detects valid input signal. LED blinking
waiting on Encoder.
3.
ID Key: Press to display information of encoder and decoder on the screen, including IP mode, MAC and IP address.
2.4.4
REAR PANEL (Receiver/Decoder, HDM-C6MWIP-R-V3)
1
.
Power: 12V 1A DC Power Jack.
2
. Stereo Audio OUT: Connects to an audio output
device such as an amplifier for audio de-embedding.
3
.
HDMI OUT: Connect to HDMI Display.
4
. RS 232 : RS-232 Data pass-through port for receiving
/sending commands to RS 232 devices.
5.
CAT5/6: Used for transporting video/audio
streams from Decoder TX units connected.
6.
Reset LED,
7.
Reset Key:
Reset LED is on for about 1 second and then off,
release this key, encoder reboots and restores to
its factory default.
1
2
3
1
2
3
4
5
6
7