WEB08S-TA Web Client Attendance RFID reader
11
3.1.4 $code
It is the unique code number of the ID card presented to the reader.
3.1.5 $cmd
It holds the action that was taken on the reader.
I.
$cmd=PU, it is sent once after the reader is just power up.
II. $cmd=REC, it is sent with an ID card is read on the reader. The card number is
stored in $code.
III. $cmd=HB, it is sent when the programmed heartbeat rate is reach. The default
heartbeat rate is 300 seconds.
IV. $cmd=SW, it is sent once when contact switch is just shorted or opened.
V. $cmd=PG, it is sent when the reader is being pinged.
3.1.6 $type
It defines the action is coming from the WEB08S-TA or the slave reader.
I.
$type=m, the action is coming from the WEB08S-TA.
II. $type=s, the action is coming from the slave reader.
3.1.7 $mode
For WEB08S-TA, $mode=TA1. So it can be used to identify the reader.
