AVCOMM Safety Products
Installation Instructions: SC500 EasyLink
Intercom
Page 1 of 4
Description:
AVCOMM SC500 EasyLink
Intercom is designed to provide powerful, clear communications for up to 6
positions while providing compatibility with all major brands of Fire/Safety headsets. It features rugged construction to
withstand the extreme conditions common to FIRE/EMS vehicles, a solid extruded aluminum framework to dramatically
reduce radio frequency interference (RFI), Thermoplastic Elastomer gaskets to seal out moisture and dust for trouble-free
performance and a streamlined circuit board with ceramic hybrid IC chips for high reliability. A complete line of AVCOMM
EasyLink
jack boxes are available to customize your application.
Streamlined installation:
AVCOMM SC500 EasyLink
intercom is
pre-wired
and
pre-assembled
to dramatically reduce
tedious soldering of individual connectors. Installation is completed in four easy steps: (1) mount the intercom U-bracket, (2)
mount the headset and remote PTT jack boxes, (3) complete wiring connections, and (4) connect power source and chassis
ground.
1. Mount the U-bracket
: Select a flat location with good support that is easy for the user to access and has sufficient room
in the back for intercom cables to be connected and on the sides to install the intercom mounting thumbscrews. Mount the
U-bracket (d) using the self-tapping screws (c). Check to make sure the U-bracket is not deformed by tightening the
screws. The intercom should not be mounted with the thumbscrews until after the final checkout has been accomplished.
SC500 Intercom Hardware
a
(4) PN#W161K-N
Thumb screw assembly
b
(4) PN#W080N-W Nylatron washer
c
(4) PN#W080M-S Self-tapping screw
d
(1) PN#XX150-00
U-bracket
e
(1) PN#W080F-S
2-AMP fuse (Fig. 2a)
Fig. 1
Note: Make sure the nylatron
washers (b) are installed between
the intercom and U-bracket (d)
a
VOL
b
SC500
d
a
a
b
c
d
b