Avaya X330W-2DS1, Руководство пользователя, Страница: 93 / 176

Layer 3 CLI Commands
Avaya X330W-2DS1 User’s Guide 71
ip directed-broadcast (Interface context)
Use the
ip directed-broadcast
command to enable net-directed broadcast
forwarding. The
no
form of this command disables net-directed broadcasts on an
interface.
Note: This command is executed from the Serial, Fast Ethernet and Fabric Fast
Ethernet interfaces.
The syntax for this command is:
[no] ip directed-broadcast
ip icmp-errors
Use the
ip icmp-errors
command to set ICMP error messages ON. The
no
form of this command to set ICMP error messages OFF.
The syntax for this command is:
[no] ip icmp-errors
ip max-arp-entries
Use the
ip max-arp-entries
command to specify the maximum number of
ARP cache entries allowed in the ARP cache. The
no
form of this command restores
to the default value of 4096. This command takes effect only after start-up.
The syntax for this command is:
[no] ip max-arp-entries
<value>
Examples:
To set the maximum number of ARP cache entries to 8000:
X330WAN-2DS1-1(configure)# ip max-arp-entries 8000
To restore the maximum number of ARP cache entries to its default:
X330WAN-2DS1-1(configure)# no ip max-arp-entries
value The space available for the IP address table. When you decrease the
number of entries, it may cause the table to be relearned more
frequently. If you do not enter a value, then the current ARP Cache size
is shown. The range of accepted values is 128 to 16384.