Avaya X330W-2DS1, Руководство пользователя, Страница: 100 / 176

Chapter 7 X330WAN CLI Commands
78 Avaya X330W-2DS1 User’s Guide
ip rip default-route-mode (Interface context)
Use the
ip rip default-route-mode
command to enable learning of the
default route received by the RIP protocol. The default state is talk-listen. Using the
X330WAN, the
no
form of the command disables listening to default routes.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip rip default-route-mode
<mode>
The possible default route modes on an interface are:
Example:
X330WAN-2DS1-1(configure)#
ip rip default-route-mode talk-only
ip rip poison-reverse (Interface Context)
Use the
ip rip poison-reverse
command to enable split-horizon with
poison-reverse on an interface. The
no
form of this command disables the poison-
reverse mechanism.
The split-horizon technique prevents information about routes from exiting the
router interface through which the information was received. This prevents routing
loops.
Poison reverse updates explicitly indicate that a network or subnet is unreachable
rather than implying they are not reachable. Poison reverse updates are sent to
defeat large routing loops.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip rip poison-reverse
talk-listen Set RIP to send and receive default route updates on
the interface.
talk-only Set RIP to send but not receive default route updates
on the interface.