Avaya WLAN Security Switch 2300 Series, Руководство по устранению неполадок и отладке, Страница: 39 / 74

39
Avaya WLAN Security Switch 2300 Series Troubleshooting and Debug Guide
Common Troubleshooting Techniques for WLAN
Location Engine 2340
Remote Access to the WLE2340 Command Line Interface
Allowing remote Access to the CLI
By default, the WLE2340 does not allow remote connectivity to the command line interface (CLI). However, it
is possible to enable this by logging to the CLI. Use the
enable command for access to privileged commands
and enter the admin password for the WLE2340. To enable the sshd process and allow remote access to the
system, use
set ssh command.
The following CLI commands are available for troubleshooting:
Command Description
show system Takes one argument and returns information about the
run time state of the WLE2340.
show system uptime Reports the current system time, and how long the
system has been up since last reboot. This information
also shows on the landing page for the Administrative
Web UI on port 8003.
show system version Reports the version number of the system. This
information also shows on the first page for the
Administrative Web UI on port 8003.
show logs status Shows memory and processor information, including
average load and a process list.
show sensors Lists all sensors registered in the system by name and IP
address, then indicates current status, the number of
devices seen by the sensor, and the packet count for the
sensor.
show logs Used to dump the log contents to standard output. Show
logs takes one or more arguments to indicate what logs
to dump.
show logs appliance Shows the appliance log including system errors, remote
session logins, database access, and so on.
show logs system controller Shows the log for the Controller process. Useful for
debugging availability issues and Web UI issues.
show logs system agent Show the log for the Agent process. Useful for
debugging sensor connectivity and tracking issues.