Avaya WLAN 8100 Series, Справочник, Страница: 340 / 382

Variable Value
ASCII. The group name must begin with a letter within
the range a..z or A..Z.
clfr-type <classifier | block> Specifies the classifier type; classifier or block.
clfr-id <1-55000> Specifies the classifier ID; range is 1–55000.
clfr-name <WORD> Specifies the classifier name or classifier block name;
maximum is 16 alphanumeric characters.
in-profile-action <1-55000> Specifies the action ID for in-profile traffic; range is 1–
55000.
in-profile-action-name <WORD> Specifies the action name for in-profile traffic;
maximum is 16 alphanumeric characters.
meter <1-55000> Specifies meter ID associated with this policy; range
is 1–55000.
meter-name <WORD> Specifies the meter name associated with this policy;
maximum of 16 alphanumeric characters.
non-match-action <1-55000> Specifies the action ID for non-match traffic; range is
1–55000. This parameter is not applicable to 5600
Series switches.
non-match-action-name <WORD> Specifies the action name for non-match traffic;
maximum is 16 alphanumeric characters.
precedence <1-15> Specifies the precedence of this policy in relation to
other policies associated with the same interface
group. Enter precedence number; range is 1–15.
Note: Policies with a lower precedence value are
evaluated after policies with a higher precedence
number. Evaluation goes from highest value to
lowest.
track-statistics <individual |
aggregate> Specifies statistics tracking on this policy, either:
• individual—statistics on individual classifiers
• aggregate—aggregate statistics
Removing QoS policies
About this task
Use the following procedure to disable QoS policy entries. Policies can be enabled using the
qos policy <policynum> enable
command.
Procedure
Remove QoS policy entries by using the following command from Global Configuration
mode.
ACLI Reference for wired networks
340 Avaya WLAN 8100 CLI Reference August 2013
Comments? infodev@avaya.com