Avaya WLAN 8100 Series, Справочник, Страница: 301 / 382

Job aid
The following table shows the field descriptions for the
show vlan igmp unknown-mcast-
no-flood
command.
Field Description
Unknown Multicast No-Flood Specifies the status of unknown multicast
filtering: enabled or disabled.
Specifying a multicast MAC address to be allowed to flood all VLANs
About this task
Use this procedure to allow particular unknown multicast packets to be flooded on all switch
VLANs.
To add MAC addresses starting with 01.00.5E to the allow-flood table, you must specify the
corresponding multicast IP address. For instance, you cannot add MAC address
01.00.5E.01.02.03 to the allow-flood table, but instead you must specify IP address
224.1.2.3.
For all other types of MAC address, you can enter the MAC address directly to allow
flooding.
Procedure
To allow particular unknown multicast packets to be flooded, enter the following from
the Global Configuration mode:
vlan igmp unknown-mcast-allow-flood {<H.H.H> |
<mcast_ip_address>}
Variable Definitions
Variable Value
<H.H.H> Specifies the multicast MAC address to be flooded.
Accepted formats are:
• H.H.H
• xx:xx:xx:xx:xx:xx
• xx.xx.xx.xx.xx.xx
• xx-xx-xx-xx-xx-xx
<mcast_ip_address> Specifies the multicast IP address to be flooded.
Displaying the multicast MAC addresses for which flooding is allowed
About this task
Use this procedure to display the multicast MAC addresses for which flooding is allowed on
all switch VLANs.
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 301