Avaya WLAN 8100 Series, Справочник, Страница: 182 / 382

Clearing the default TFTP server with CLI
About this task
The default TFTP server can be cleared from the switch and reset to 0.0.0.0 with the following
two commands:
• no tftp-server
• default tftp-server
Configuring a default TFTP server with CLI
About this task
The switch processes that make use of a TFTP server often give the switch administrator the
option of specifying the IP address of a TFTP server to be used. Instead of entering this address
every time it is needed, a default IP address can be stored on the switch.
A default TFTP server for the switch is specified with the tftp-server command. The syntax of
this command is:
tftp-server <A.B.C.D>
To complete the command, replace
<A.B.C.D>
with the IP address of the default TFTP server.
This command must be executed in the Privileged EXEC command mode.
Configuring default clock source
About this task
This command sets the default clock source for the switch.
The syntax for this command is:
clock source {rtp | sntp | sysUpTime}
Substitute
{rtp | sntp | sysUpTime}
with the clock source selection.
Run this command in Global Configuration command mode.
Configuring daylight savings time with CLI
About this task
Use the following procedure to configure the daylight savings time adjustment with CLI:
Procedure
1. In CLI, set the Global Configuration command mode.
configure
2. Enable sntp server.
ACLI Reference for wired networks
182 Avaya WLAN 8100 CLI Reference August 2013
Comments? infodev@avaya.com