Avaya W310, Справочник по командам

Страница: 422 / 440

Chapter 18 User, User Group, and RADIUS Commands
406 Avaya W310 Command Reference Guide
Example:
Related Commands:
• Use the set radius authentication command to enable or disable RADIUS
authentication for the W310 switch.
• Use the
set radius authentication retry-number
to set the number of
times the switch sends an access request when there is no response.
• Use the set radius authentication retry-time command to set the time
that the switch waits before resending an access request.
• Use the
set radius authentication secret
command to enable secret
authentication for the W310 switch.
• Use the set radius authentication server command to set the IP address
(and shared secret) of the primary or secondary RADIUS Authentication server.
• Use the
set radius authentication udp-port
command to set the RFC
2138 approved UDP port number for RADIUS authentication.
• Use the set radius secret command to set the RADIUS shared secret.
show user group table
User level: supervisor
Command Mode: Root, User Group
Use the
show user group table
command to show the user group table attributes and
default-user-group.
Syntax:
The syntax for this command is:
show user group table
W310-1> show radius authentication
RADIUS authentication parameters:
---------------------------------
Mode: Enabled
Primary-server: 192.168.42.252
Secondary-server: 192.168.48.134
Retry-number: 4
Retry-time: 5
UDP-port: 1645
Shared-secret: sodot