Avaya W310, Справочник по командам

Страница: 302 / 440

Chapter 11 W310 Port Commands
286 Avaya W310 Command Reference Guide
Example:
set port speed
User level: privileged, supervisor.
Use the
set port speed
command to configure the speed of a port or range of 10/
100BASE-T ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An error
message is generated if you attempt to set the speed when auto negotiation is enabled
!
This command cannot be executed on ports 51, 52 (Gigabit SFP ports). An error
message is generated if you attempt to perform the
set port speed
command for
these ports that can only work at 1000 Mbps speed.
Syntax:
The syntax for this command is:
set port speed <module/port> {10MB | 100MB | 1GB}
Example:
To set the speed of port 1 to 100 Mbps
W310-1# set port spantree priority 1/4 128
port 1/4 spantree priority is 128
Syntax Description
<module/port> 1/port number or range of port numbers. To specify a range of
ports, use a hyphen between the two port numbers. For example:
•
To specify port 1, type 1/1
• To specify ports 1 to 5, type 1/1-5
{10MB | 100MB
| 1GB}
10MB – 10 Mbps (Ethernet)
100MB – 100 Mbps (Fast Ethernet)
1GB – 1 Gbps (Gigabit Ethernet)
W310-1# set port speed 1/1 100MB
Port 1/1 speed set to 100 Mbps.