Avaya W310, Справочник по командам

Страница: 291 / 440

Chapter 11
Avaya W310 Command Reference Guide 275
set port negotiation
User level: privileged, supervisor.
Use the
set port negotiation
command to enable or disable the link negotiation
protocol on the specified port. This command is available on Fast Ethernet or Gigabit
Ethernet ports.
• When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are
determined by auto-negotiation.
• If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet
ports.
For Fiber Gigabit Ethernet ports it can determine the flow control (pause) mode only.
Syntax:
The syntax for this command is:
set port negotiation <module/port> {enable | disable}
Example:
To disable auto negotiation on port 1:
Syntax Description
<module/port> 1/port number or range of port numbers. To specify a range of
ports, use a hyphen between the two port numbers. For example:
•
To specify port 1, type 1/1
• To specify ports 1 to 5, type 1/1-5
enable Enables port negotiation protocol.
disable Disables port negotiation protocol.
W310-1# set port negotiation 1/1 disable
Link negotiation protocol disabled on port 1/1.