Avaya W310, Справочник по командам

Страница: 286 / 440

Chapter 11 W310 Port Commands
270 Avaya W310 Command Reference Guide
set port flowcontrol
User level: privileged, supervisor.
Use the
set port flowcontrol
command to set the send/receive mode for flow-
control frames (IEEE 802.3x or proprietary) for a full duplex port. Each direction (send or
receive) can be configured separately.
Syntax:
The syntax for this command is:
set port flowcontrol {receive | send | all} <module/port> {off
| on | proprietary}
Syntax Description
receive Indicates the ability of the port to receive administrative status
from a remote device.
Available only for Gigabit Ethernet ports with negotiation set to
off.
send Indicates the ability of the port to send administrative status to a
remote device.
Available only for Gigabit Ethernet ports with negotiation set to
off.
all Indicates the ability of the port to both send and receive
administrative status (symmetric flow control).
<module/port> 1/port number or range of port numbers. To specify a range of
ports, use a hyphen between the two port numbers. For example:
•
To specify port 1, type 1/1
• To specify ports 1 to 5, type 1/1-5
off Disables the port from receiving or sending administrative
status:
•
set port flowcontrol receive <module/
port> off
disables receiving of administrative status.
•
set port flowcontrol send <module/port>
off
disables sending of administrative status.
•
set port flowcontrol all <module/port>
off
disables both receiving and sending of administrative
status.
1 of 2