Avaya W310, Справочник по командам

Страница: 270 / 440

Chapter 11 W310 Port Commands
254 Avaya W310 Command Reference Guide
set port channel
User level: privileged, supervisor.
Use the
set port channel
command to enable or disable a Link Aggregation Group
(LAG) interface on the switch. To create a LAG, you must specify a LAG name. There is no
default name.
You can also add or remove a port from an existing LAG. When adding or removing a port
to an existing LAG, type the same LAG-name. All ports in the LAG are configured with the
parameters of the first port that is added to the LAG. These parameters include port
administrative status, speed, duplex, auto negotiation mode, VLAN ID, tagging mode,
binding mode, and priority level.
The ports added to a LAG must belong to the same LAG group.
When adding a port to an existing LAG, type the same LAG name, otherwise you will create
a new LAG.
Syntax:
The syntax for this command is:
set port channel [<port_list>] [on | off] <name>
!
To define a name that includes spaces, you must enclose the entire name in quotation
marks, for example “new york”.
Example:
Syntax Description
<port_list> A list of ports to be aggregated in the format 1/port
[on | off] on enables the channel for the specified ports
off disables the channel for the specified ports
<name> Channel name
W310-1# set port channel 1/5-6,8 on my-channel
Port 1/5 channel mode set to on 1/102
Port 1/6 was added to channel 1/102
Port 1/8 was added to channel 1/102