Avaya W310, Справочник по командам

Страница: 107 / 440

Chapter 8
Avaya W310 Command Reference Guide 91
beacon-period
User level: privileged, supervisor.
Command Mode: Radio card, Template
Use the
beacon-period
command to specify the number of time units (TU) that a station
(AP) will use for scheduling beacon transmissions. Use the [no] form of this command to
return the beacon period to its default value of 12.
Syntax:
The syntax for this command is:
[no] beacon-period <period>
Message:
After this command is initiated, the LAP must reboot for any change to this setting to take
effect. The following message displays after you initiate this command:
This command will reboot the LAP(s). Do you want to continue (Y/N)?
• Type Y to reboot the LAP.
• Type N to cancel the reboot. The change in this setting will not take effect.
Example:
To set the beacon period:
To return to the default unicast transmission rate:
Syntax Description
<period> Number of TUs a station will use to schedule beacon
transmissions. This value is transmitted in beacon and probe
response frames. The range is 1 to 65535. The default setting is
12.
W310-1(super/LAP lobby/802.11a first-slot)# beacon-period
900
Done!
W310-1(super/LAP lobby/802.11a first-slot)# no beacon-
period
Done!