Avaya Secure Router 2330, Установка оборудования

Страница: 60 / 126

Electrostatic alert:
ESD
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack when you work with interface modules. The router does not have
an ESD jack—connect the antistatic wrist strap to an ESD jack at your site.
Caution:
Risk of equipment damage
Always handle interface modules by the edges, or use the levers, where applicable.
Caution:
If you do not install a module in the slot, be sure to keep the metal cover plate in place over
the slot. Removing the cover plate impedes airflow and proper cooling of the unit.
Prerequisites
• Ensure you have a Phillips #2 screwdriver.
• Ensure you have securely installed the Voice Carrier Medium Module in the Secure
Router 4134 chassis.
Procedure steps
1. Use a Phillips screwdriver to remove the slot cover plate from the slot in which you
will install the Small Module.
2. Align the Small Module with the slot and the slot module guides.
3. Slide the Small Module into the Voice Carrier Medium Module until the Small Module
connector touches the back panel of the Voice Carrier Medium Module.
4. Push gently, but firmly, to seat the Small Module connector in the Voice Carrier
Medium Module.
5. Use a Phillips screwdriver to tighten the two captive screws that secure the Small
Module to the Voice Carrier Medium Module.
Hot swapping interface modules
If an interface module fails and you must replace it, you can hot swap the module. All of the
Secure Router 2330/4134 external interface modules are hot swappable.
Use the procedure in this section to hot swap all external interface modules.
Important:
Hot swap an interface module only if the Secure Router 2330/4134 recognizes the card.
When a card fails to initialize, the Secure Router 2330/4134 should still recognize that the
Installing Avaya Secure Router 2330/4134 hardware components
60 Installation — Hardware Components August 2013
Comments? infodev@avaya.com