Avaya S8700-Series, Установка и настройка

Страница: 83 / 122

Issue 8 May 2009 83
Chapter 8: Installation verification
This chapter provides the following information about how to verify the server installation and
configuration:
l
Testing the IPSI circuit packs
l
Testing the license file
l
Checking LED status indicators
- Servers
- Avaya Ethernet switches
- Uninterruptible power supplies (UPSs)
- Circuit packs
Testing the IPSI circuit pack
The following steps test the clock and packet interface components within the TN2312BP IPSI
circuit pack.
Note:
Note:
With duplicated servers, use the active server.
1. In a SAT command line, type
test ipserver-interface UUC
and press Enter ,
where
UUC
is the cabinet and the carrier in which the circuit pack is located.
2. Verify that the Test Results screen shows PASS in the Results column.
Testing the license file
!
Important:
Important:
Wait at least 30 minutes after you install the Communication Manager license
before you run this test.
Note:
Note:
With duplicated servers, use the active server.
1. On a SAT command line, type
test license
and press Enter .
2. Verify that the Test Results screen shows PASS in the Results column.