Avaya S8400, Установка и настройка, Страница: 44 / 80

Chapter 6: IP interface configuration
44
Installing and Configuring the Avaya S8400 Media Server February 2007
11. Type
show control interface
and press Enter .
The system displays IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
12. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr
, where
gatewayaddr
is the customer-provided
IP address for their gateway.
13. Type
quit
and press Enter to save the changes and exit the SIPI session.
14. Log back in to the SIPI using SSH.
15. Use
show control interface
to verify the administration.
16. Type
exit
and press Enter .
Setting the VLAN and diffserv parameters
1. Connect to the SIPI and log in as
craft
.
2. To display the quality of service values, type
show qos
and press Enter .
3. Use the
set
commands in the list below to set the VLAN, diffserv, and port parameters. If
the customer does not specify different values, use these recommended values.
Note:
Note:
Use Help to obtain syntax guidelines for these commands.
!
Important:
Important:
The settings for these parameters on the SIPIs must be consistent with the
settings on the media servers and other network devices such as Ethernet
switches.
●
set vlan priority 6
● set diffserv 46
●
set vlan tag on
● set port negotiation 1 disable
●
set port duplex 1 full
● set port speed 1 100
4. Type
show qos
and press Enter to check the administered values.
5. Type
reset
and press Enter to capture the updated parameter values.
The reset terminates the administration session and automatically logs you out.
6. Log in again and use the
show qos
command to ensure that the parameter settings are
correct.