Avaya S6200, Руководство пользователя, Страница: 47 / 60

Installing the TP-260
Issue 1 July 2006 47
2. Make sure Antistatic Bag Seal in which TP260 Gateway board is packed is not broken.
Remove the board gently, from the Antistatic Bag.
3. Remove the handle from the PCI Board by unscrewing two screws located on either end of
4. Record the following board information:
●
Serial Number of Trunk Pack Board
●
Serial Number of Media Processing Board
●
Serial Number of PCI Base Board
●
MAC Address of the Board
●
Product Serial Number of the board
5. Store a copy of the AudioCodes packing list.
Installing the Gateway Board into the S6200 Application Server
Follow these steps to install the gateway board in the media server.
1. Verify that the 6200 Media Server power is switched off before installing Gateway Board.
2. Pull the slot board holder latch on the rear side of the server, before installing the board.
3. Open the server cover as follows:
a. Open Fan Door-A and Fan Door-B by pushing the latches in the direction of the arrows
printed on the latches located on the fan doors.
Two flat head screws are located at either
end of the handle. The screw head faces the
solder-side of the board.