Avaya QuesCom 400, Руководство по установке и пусконаладке

Страница: 31 / 116

2. At the REQ prompt, type
NEW
and press Enter .
3. At the FEAT prompt, type
CDP
and press Enter .
4. At the TYPE prompt, type
DSC
and press Enter .
5. At the DSC prompt, type
DN
for the pilot number and press Enter .
6. At the FLEN prompt, type the length of the DN and press Enter .
7. At the DSP prompt, press Enter .
8. At the RLI prompt, type the value for the Route List Block and press Enter .
Creating a PMS PTY port
About this task
Create a PMS PTY port to enable HMS 400 communication with the switch to perform functions
such as check in, check out, and Class of Service (CoS) or Class of Restriction (COR)
change.
Prerequisites:
• The PMS PTY port must be the lowest-numbered PTY port.
• Create at least two additional PTY ports that have higher port numbers than the PMS PTY
port. For information about creating additional PTY ports, see Creating additional PTY
ports on page 32.
Procedure
1. At a command line, type
LD 17
and press Enter .
2. At the REQ prompt, type
CHG
and press Enter .
3. At the TYPE prompt, type
CFN
and press Enter .
4. At the ADAN prompt, type
NEW TTY X
(where X is the port number) and press
Enter .
5. At the CTYP prompt, type
PTY
and press Enter .
6. At the PORT prompt, type the port number and press Enter .
The port number range is usually 0 to 7 but it can match X .
7. At the DNUM Y prompt, press Enter .
8. At the DES prompt, type a description (for example, PMSI) and press Enter .
9. At the FLOW prompt, type
NO
and press Enter .
10. At the USER prompt, type
BGD PMS
and press Enter .
Creating a PMS PTY port
Avaya Hospitality Messaging Server 400 Installation and Commissioning March 2012 31