A test email will be sent to the address configured for the array. Confirm the email
configuration settings if an email is not received at the anticipated address.
9. Click
Save
.
Related links
Configuring monitoring and alerts
on page 12
Nimble CS1000 and VPFM alarms
About this task
The Nimble CS1000 does not currently send alarms or notifications to VPFM. Configure email alerts
to receive alarms and notifications from the device.
Use the following procedure to configure email alerts.
Procedure
1. Open a new browser window or tab.
2. Enter the management IP address of the storage array.
3. Log in to the management interface with the Administrator credentials.
4. Select
Administration
>
Alerts and Monitoring
>
from the menu.
5. Enter a reporting email address in the
Send From Address
section.
Note:
This address is displayed in the
From
field of an email when an alarm or notification is
sent from the array. This does not have to be a valid email address. However, the
address should provide enough information to be clearly identifiable to the recipient.
For example, a corporation has 2 Pods named
ExampleCorpCallCenter
and
ExampleCorpSAN
each with one storage array. The administrator could enter
and
when configuring each device to
identify where an alarm or notification originates.
6. Click
Add
in the
Send To Addresses
section.
7. Enter an email address to send alarms and notifications.
8. Repeat the previous two steps for each address to receive alarms and notifications.
9. Select
Send event data to Nimble Storage Support
if you wish to also send this
information directly to Nimble Support.
10. Enter the information for your corporate SMTP server
SMTP Server
section.
11. Set the level at which alarms and notifications are sent in the
Alert Options
section.
12. Click
Test
to test the settings.
Nimble CS1000 and VPFM alarms
October 2017
Troubleshooting the Avaya Pod Fx
™
13