Avaya Media Gateway G350, Руководство по обслуживанию

Страница: 261 / 332

Access and login procedures
Log in methods
Maintenance of the Avaya G350 Media Gateway 261
June 2004
Open the Communication Manager SAT
screens
To run Communication Manager SAT:
1
If you already have a valid Telnet session in progress, access the SAT program by typing
sat
or
dsat
at the Telnet prompt.
2
Log in to the S8300 as craft .
Enter your login confirmation information as prompted:
— Password prompt. Type your password in the Password field, and click Login or press
Enter again.
— ASG challenge. If the login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press
Enter
.
3
Enter your terminal type. Accept the default value, or enter the appropriate type for your
computer. For example, you may use type
ntt , a terminal type available for Windows NT4.0 or
Windows 98. For Windows 2000, use w2ktt .
The system displays the SAT interface.
4
Enter SAT commands as appropriate.
Log in to the G350 Media Gateway interface
with a direct connection to the Services port
Use this procedure to log in to the G350 Media Gateway interface when you have a direct connection
with your laptop to the S8300 Services port.
NOTE:
If you are upgrading an S8300/G350 remotely, connect to the customer LAN and telnet to
the IP address of the G350 interface. The IP address is the address assigned on the
customer LAN, not 192.11.13.6.
To log in to the G350 interface via the Services port:
1
With a direct connection to the S8300 services port, telnet to the S8300 IP address:
Type telnet 192.11.13.6 .
2
Login as
craft
or
cust
.
3
Telnet to the Layer 2 interface.
Type
telnet <xxx.xxx.xxx.xxx>
, where <xxx.xxx.xxx.xxx> is the IP address of the G350 interface
on the customer’s LAN.