Chapter 3: Powering up the phone and
installing the GSPPoE power
injector unit
GSPPoE power injector unit
Caution:
The GSPPoE power injector does not have an On-off switch. It is turned on when plugged-in
to an AC power source. Do not provide power to the GSPPoE power injector from an AC
power source that is controlled by an On-off switch.
The GSPPoE power injector kit contains one GSPPoE unit and one CAT-5E cable. Check the
following before installing the GSPPoE power injector:
• Do not cover the GSPPoE power injector or block the airflow to the GSPPoE with any foreign
objects. Keep the GSPPoE power injector away from excessive heat and humidity and free
from vibration and dust.
• Ensure that the cable length from the Ethernet network source to the terminal does not
exceed 100 meters (333 feet). The GSPPoE is not a repeater and does not amplify the
Ethernet data signal.
• Do not use the GSPPoE if the data networking switch provides PoE. The GSPPoE must not
be used with networking hub type devices.
• Ensure that the AC power source is properly grounded and the PoE injector is connected
with an appropriate power cable.
The C5 power cables are required with the power solution. The comcodes for the C5 power cables
are:
• 700511982 - C5 Pwr Cord Nar
• 700511978 - C5 Pwr Cord Eu/Russia
• 700511810 - C5 Pwr Cord Brazil
• 700511983 - C5 Pwr Cord Uk
• 700511814 - C5 Pwr Cord Taiwan
• 700511976 - C5 Pwr Cord China
June 2018
Using Avaya Global Single Port Power Over Ethernet Injector
7