Avaya G700, Установка и обновление, Страница: 93 / 808

About installation and cabling
Issue 10.2 May 2007 93
5. For an S8300B, push steadily and firmly until the faceplates of the S8300 Media Server and
the LED module are even and then push the two units into the housing together.
For an S8300C, push steadily until the faceplate of the S8300 Media Server is even with the
LED module faceplate.
6. Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide grounding.
Medium length and short pins will provide power and signal.
7. Tighten the captive screws on the S8300 Media Server module.
!
WARNING:
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to radiated emissions requirements, all captive screws
must be securely tightened such that they cannot be loosened without the use of
a tool.
Figure 11: Tighten screws
Inserting media modules
Following the planning documentation, you can insert the required media modules into their
designated bays. The G700 Media Gateway can accommodate up to four media modules, or
plug-in circuit packs. The choice of media modules is dictated by the offer selected by the
customer and the configuration of the system.
Consult the planning documentation and the order form to determine which modules you will be
installing. The planning documents also indicate into which slots the modules are to be inserted.
The media modules available at this time are:
●
Avaya MM710 T1/E1 Media Module
●
Avaya MM760 VoIP Media Module (support G.723, G.726, and G.729)
●
Avaya MM711 Analog Media Module (8 ports, stations or trunks)
●
Avaya MM714 Analog Media Module (4 station ports and 4 trunk ports)
Note:
Note:
Analog DID trunk connections are to be associated with the ports labeled "Line"
and not "Trunk".
msdcsrwc LAO 092006
ALM
APP
ACT
OK TO
REMOVE
S8300C
C_V1
SHUT DOWN
SERVICES USB 1 USB 2 USB 3