Avaya G700, Установка и обновление, Страница: 669 / 808

Upgrade the G700 Firmware
Issue 10.2 May 2007 669
b. Log in as craft.
c. At the Linux prompt, type
cd /var/home/ftp/pub,
and press Enter .
d. The Linux prompt reappears. The current directory has changed to /var/home/ftp/pub.
e. At the Linux prompt, type
cp
<
firmware_filename
>
/tftpboot
, and press Enter to
copy a single firmware file to the /tftpboot directory. To copy multiple firmware files (most
firmware files have an .fdl suffix), use the command
cp *.fdl /tftpboot
.
f. The Linux prompt reappears. The firmware file or files have been copied to the /tftpboot
directory.
g. Repeat step 4, if necessary, for other firmware files you want to install.
h. At the Linux prompt, type
cd /tftpboot
.
i. The Linux prompt reappears. The current directory has changed to /tftpboot.
j. At the Linux prompt, type
ls
, and press Enter .
k. A list of files in the directory appears.
l. Check the directory to make sure the firmware files you want to install are listed.
Determining which firmware to install on the G700
Conduct the following procedure to compare software versions running on the G700 processors
and media modules with the versions in you planning documents. If the versions do not match,
you need to install the new firmware for those components.
To determine if new firmware for the P330 stack processor is necessary
1. Access the stack processor. See one of the following:
●
Logging in to the P330 Stack Processor with a Direct Connection to the S8300 Services
Port
on page 62
●
Logging in to the P330 Stack Processor with a LAN Connection on page 63
●
Logging in to the P330 Stack Processor with a Direct Serial Connection on page 64
●
Logging in to the P330 Stack Processor with Device Manager on page 64
2. At either the P330-1(super)# or P330-1(configure)# prompt, type
dir
.
The system displays the directory list of software for the P330 stack processor.