Avaya G700, Установка и обновление, Страница: 638 / 808

Manual upgrade of an existing S8300B or S8300C and G700 to R4.0
638 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Removing the administration for the IA770 integration if CWY1
board is used
Note:
Note:
If the S8300 is configured as an LSP, skip to Upgrade the S8300 on page 657.
!
CAUTION:
CAUTION:
Communication Manager Release 4.0 does not support the CWY1 method of
integration of IA770 INTUITY AUDIX Messaging. As a result, if the S8300 Media
Server uses a CWY1 board to integrate the IA770 INTUITY AUDIX application,
you must remove the current switch integration administration now. You will
administer the integration for H.323 after the upgrade.
For instructions on removal of existing CWY1 administration, see Administering Media Servers
to work with IA770 .
Note:
Note:
For Releases 2.0 and 2.1 of Communication Manager that use IA770, you cannot
remove messaging from the Media Gateway screen in the SAT interface before
the upgrade. Therefore, you must remove messaging from Slot V8 of the Media
Gateway screen after the upgrade, then administer the H.323 integration.
Completing pre-upgrade tasks — if the target S8300 is the primary
controller
If the S8300 is configured as an LSP, skip to Upgrade the S8300 on page 657.
!
CAUTION:
CAUTION:
If you are upgrading an S8300 primary controller that has LSPs registered to it,
the LSPs must be upgraded
before the primary controller. (You can use the SAT
command,
list media-gateway
, to see if there are LSPs registered to the
S8300.)
Perform the following procedures if you are upgrading an S8300 that is configured as a primary
controller:
●
To display IA770 alarms, if IA770 is enabled
●
To clear alarms
●
To check link status
●
To record all busyouts
●
To disable scheduled maintenance