Avaya G700, Установка и обновление, Страница: 613 / 808

Post-upgrade tasks
Issue 10.2 May 2007 613
To "session" over to another G700/P330/C360 in a stack
1. At the MG-001-1(configure)# prompt, type
session stack
The P330-1(configure)# prompt appears.
2. At the P330-1(configure)# prompt, type
session <mod_num> mgp
where <mod_num> is the next P330 or C360 processor in the stack.
If you are currently logged in to the master stack processor, <mod_num> would be
2
, for
the second G700/P330/C360 processor in the stack.
3. For other G700s in the stack, repeat the steps described previously to install firmware for
the stack processor, MGP, and media modules.
Installing G700 firmware in a remote, no stack configuration
If additional G700 media gateways are supported in the configuration, but they are not attached
as a stack, then you must configure each G700, with all of its devices, including the P330
processors. Additionally, you must check firmware and update the firmware as required.
Post-upgrade tasks
Complete the following tasks after you have finished the upgrade:
Stopping IA770 INTUITY AUDIX Messaging, if installed
After the upgrade is complete, perform the following post-upgrade tasks.
1. From the Maintenance Web Page , select Messaging Administration from the
Miscellaneous menu.
The Messaging Administration Web page is displayed in a new Web browser window.
2. From the Messaging Administration Web page, select Utilities .
The Utilities Web page is displayed.
3. Select Stop Messaging Software .
The Stop Messaging Software Web page is displayed.
4. Select the Stop button.
The shutdown of the messaging server will begin once all users have logged off from IA
770. Once the server has been stopped, the Web page will display status information. Once
this process has begun, it will take a few minutes to complete the shutdown.