Avaya G700, Установка и обновление, Страница: 612 / 808

Manual upgrade of an S8300A and G700 to R4.0
612 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
4. To set the rapid spanning tree version, type
set spantree version
rapid-spanning-tree
and press Enter .
The 802.1w standard defines differently the default path cost for a port compared to STP
(802.1d). In order to avoid network topology change when migrating to RSTP, the STP path
cost is preserved when changing the spanning tree version to RSTP. You can use the
default RSTP port cost by typing the CLI command
set port spantree cost auto
.
Note:
Note:
Avaya P330s now support a "Faststart" or "Portfast" function, because the
802.1w standard defined it. An edge port is a port that goes to a device that
cannot form a network loop.
To set an
edge-port , type
set port edge admin state module/port
edgeport
.
For more information on the Spanning Tree CLI commands, see the Avaya P330 User’s Guide
(available at http://www.avaya.com/support ).
Installing new firmware on other G700 media gateways
Installing G700 firmware in a stack configuration
If the customer has multiple G700 media gateways connected in an IP stack, you can stay
connected to the master G700/P330 and "session" over from the master P330 Stack Processor
to the next G700 in the stack. If you are dialed in remotely, you should have automatically dialed
in to the stack master. For a local installation, you should have plugged your laptop into the
stack master P330, which you can identify by the LED panel on the upper left of each G700 or
P330/C360 device in the stack.
The LEDs signal as follows:
●
On the G700 Media Gateway: a lit MSTR LED indicates that this unit is the stack master.
●
On the P330 or C360 device: a lit SYS LED indicates that this unit is the stack master.
The G700 and P330/C360 at the bottom of the stack is module number 1, the next module up is
number 2,. and so on. However, the stack master can be any module in the stack, depending on
the actual model, the vintage firmware it runs, and whether the S8300 is inserted into it.
Note:
Note:
You do not need to configure the other P330 or C360 processors in the stack.
These will use the IP address and IP route of the master stack processor.
However, you will need to check firmware on all devices of the other G700s in the
stack, including the media gateways themselves, and update the firmware as
required.
You may also use the "session stack" command to access other standalone P330
or C360 processors in the stack (those that are not part of a G700 unit).