Avaya G700, Установка и обновление, Страница: 555 / 808

Preparing for the upgrade to R4.0 on-site
Issue 10.2 May 2007 555
Preparing for the upgrade to R4.0 on-site
When you arrive on-site, you must perform the following tasks in preparation for the upgrade to
release 4.0.
Accessing the S8300
To perform the installation and upgrade procedures you will need to connect your laptop to the
S8300 Services port using a crossover cable. For a direct connection to the S8300 Services
port, your laptop must be properly configured. See
Laptop configuration for direct connection to
the services port on page 42.
You will use telnet, SSH, and the Maintenance Web Interface to perform the procedures. See
the following:
●
Accessing the server’s command line interface with SSH on page 55
●
Logging in to the media server from your laptop using Telnet on page 56
●
Logging in to the S8300 Web Interface from your laptop on page 57
Removing the administration for the IA770 integration if CWY1
board is used
Note:
Note:
If the S8300 is configured as an LSP, skip to Checking current software
release on page 556.
!
CAUTION:
CAUTION:
Communication Manager Release 4.0 does not support the CWY1 method of
integration of IA770 INTUITY AUDIX Messaging. As a result, if the S8300 Media
Server uses a CWY1 board to integrate the IA770 INTUITY AUDIX application,
you must remove the current switch integration administration now. You will
administer the integration for H.323 after the upgrade.
For instructions on removal of existing CWY1 administration, see Administering Media Servers
to work with IA770 .
Note:
Note:
For Releases 2.0 and earlier of Communication Manager that use IA770, you
cannot remove messaging from the Media Gateway screen in the SAT interface
before the upgrade. Therefore, you must remove messaging from Slot V8 of the
Media Gateway screen after the upgrade, then administer the H.323 integration.