Avaya G700, Установка и обновление, Страница: 519 / 808

Administer Communication Manager
Issue 10.2 May 2007 519
Administering an S8300 primary controller
!
CAUTION:
CAUTION:
This administration applies only to the primary controller. If the S8300 you
installed is configured as an LSP, do
not perform this administration on it.
Translations are automatically copied to the LSP from the S8300 primary
controller.
Skip this section and go to Administering an S8400, S8500, or S8700-series primary
controller on page 524 if the primary controller is an S8400, S8500, or S8700-series Media
Server.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see
Administrator Guide to Avaya Communication
Manager , 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager , 555-233-504.
!
CAUTION:
CAUTION:
Before continuing, be sure you have saved translations in Communication
Manager.
Begin by resetting the system.
To reset the System
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6 .
2. Log in, and open a SAT session (type sat or dsat ).
3. At the SAT prompt, type
reset system 4
The system reboots.
4. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type
change node-names ip
to open the Node Names
screen.