Avaya G700, Установка и обновление, Страница: 415 / 808

Install the S8300
Issue 10.2 May 2007 415
Install the S8300
Inserting the S8300
To insert the S8300
!
CAUTION:
CAUTION:
Be sure to wear a properly grounded ESD wrist strap when handling the S8300
Media Server. Place all components on a grounded, static-free surface when
working on them. When picking up the hard drive, be sure to hold it only on the
edges.
1. Connect the DVD/CD-ROM drive to the S8300 with the following steps:
Note:
Note:
You must do this before you completely seat the media server in the slot.
a. Connect the USB cable into one of the USB ports on the faceplate of the S8300.
b. Connect the other end of the USB cable to the CD-ROM or DVD/CD-RW drive.
c. If you are using an Addonics DVD/CD-RW drive, connect the power cord to the drive and
an electrical outlet.
Note:
Note:
The TEAC drive and S8300/S8400 DVD/CD-RW drive get their power from the
server over the USB connection.
d. If you are using an Addonics DVD drive, set the power source switch on the side to EXT ,
not USB .
e. If you are using an S8300/S8400 DVD/CD-RW drive, set the on/off switch to On .
Be sure to set the S8300/S8400 drive to Off when not in use.
2. Insert the Communication Manager Software Distribution CD in the drive.
!
CAUTION:
CAUTION:
Verify AC power connection to the laptop. Do not attempt to remaster the S8300
using only the laptop’s battery power.
3. For the S8300B circuit pack only, the LED module (above slot V1) must also be removed or
inserted together with the S8300. Do the following:
●
Disengage the LED module and remove it from the G700.
●
Insert both the LED panel and S8300B circuit pack about 1/3 of the way into the guides
(the guides are in slot V1 for the S8300 and above slot V1 for the LED panel).