Avaya G700, Установка и обновление, Страница: 291 / 808

Run the Upgrade Tool to upgrade the primary controller, LSPs, and G700 media gateways
Issue 10.2 May 2007 291
If the server is an LSP, stop and start Communication Manager
If you are upgrading an LSP, you must restart Communication Manager to sync the license for
LSP status.
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6 .
2. Type
stop -caf
3. Type
start -cf
Saving translations
Note:
Note:
If the S8300 you are upgrading is an LSP , perform this task on the primary
controller.
To save translations
1. In the SSH session, open a SAT session. and log in as craft (or dadmin ).
2. If the S8300 you are upgrading is a primary controller, at the SAT prompt, type
save
translation
and press Enter .
3. If the S8300 you are upgrading is an LSP, then on the primary controller, type
save
translation lsp
and press Enter . This command distribute saved translations out to
the LSPs.
When the save is finished, the system displays the message,
Command successfully completed.
The system automatically performs a reset system 4. If you are upgrading an LSP, you are
logged out.
Ensuring the MGP default gateway IP address is set
Communication Manager release 4.0 requires that the built-in VoIP module of the G700 Media
Gateway has a default gateway IP address. To ensure that this IP address is set, perform the
following steps:
1. Log into the G700 Media Gateway console port (see Logging in to the P330 Stack
Processor with a Direct Serial Connection on page 64).
2. Type
configure
to obtain the P330-1(configure)# prompt.
3. At the P330-1(configure)# prompt, type
session mgp
.