Avaya G600, Инструкция по установке

Страница: 51 / 274

51 Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Configure the SNMP Modules in the UPSs
May 2003
administrator. If the defaults are left administered this could create a serious security issue. For
example, the default Set community name string, with it’s widely known value of Private, could
be used to shutdown power to the UPS loads via SNMP message.
7
When completed, disconnect the services laptop computer from the UPS.
8 Connect one end of a CAT5 cable to the RJ45 connector on the UPS 1 SNMP module
and the other end to the next available port on the Ethernet switch for Control Network A
(CNA).
9
Repeat steps 5 thru 7 for the UPS 2 SNMP module. Use the following address, mask, and
gateway information:
Duplex reliability configurations
For duplex reliability configurations use the following address and cable connection
information:
NOTE:
For duplex reliability configurations there are two servers and two UPS units. However,
there is only one control network. The following entries provide addresses on CNA for
UPS 2.
•
UPS IPaddress / Subnet mask = 198.152.255.238 / 255.255.255.0
• Default Gateway IP address = 198.152.254.202
•
Host Table trap receiver IP address = 198.152.254.202
• Local network administrator supplied information as required for Get and Set
community name strings.
• Cable the RJ45 connector on the UPS 2 SNMP module to the next available port on the
Ethernet switch for Control Network A (CNA).
Setting selected traps (alarming)
The default is to set all traps, which may result in large log entries. Therefore, only set the
following traps. Refer to the User’s Guide that comes with the SNMP module for the menus and
commands for setting these traps.
• UPS on Battery—Indicates AC fail with pending shutdown based on battery reserve
available
• UPS in Bypass—Failure either Failed UPS or overload
•
Replace battery—Failure of periodic (28day) battery test indicating battery needs to be
replaced.