Avaya G600, Инструкция по установке

Страница: 229 / 274

229 Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Completing the Installation Administration
May 2003
Enable alarms to INADS via SNMP
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device see (Avaya personnel only):
http://135.8.11.4/team-sra/
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1 Click Start > Run to open the Run dialog box
2
Type telnet 192.11.13.6 and press
Enter
.
3 Log in as craft or dadmin (if business partner).
4
At the prompt type
almsnmpconf -d ipaddress -c community name and press
Enter
. Where ipaddress is the trap receiver address for the SSG device and
community name is the community string name required by the SSG device.
5 Type almsnmpconf
and press
Enter
. Verify that the correct information was
entered.
6 At the prompt type
almenable -s y and press
Enter
.
7
Type
almenable and press
Enter.
Verify that the SNMP alarm origination is
enabled. If used, verify that alarm origination via modem is still enabled.
Register the system
Follow the existing process and procedures to register the Avaya
TM
S8700 Media Server.
Let customers know what the default LAN security settings are; they may want to change them
after installation. Make sure they are aware that if the following items are not set, they will not
have remote access to the media servers:
•
telnet—no Telnet access
• https—no Web access
•
def-sat—no SAT access