Avaya G600, Инструкция по установке

Страница: 21 / 274

21 Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway
Mounting Hardware in the Rack
May 2003
Mounting Hardware in the Rack
Refer to Getting Started with the Avaya™ S8700 Media Server with an Avaya™ G600 Media
Gateway for information on mounting the hardware in the rack.
Connect the USB Modems
!
WARNING:
Once the modems are cabled to the servers, do not unplug the modem USB cable on the
active server. If modems must be changed, do it on the standby server.
Required options in the modems will be set by the operating system on the server. There are no
options to set on the modems themselves.
Co-located servers
Both servers share one telephone line.
1 Install two RJ11 jack outlets wired to a single 1MB (Measured Business) telephone line.
2
Connect the RJ11 jacks, one to each server, with the modular telephone cord supplied
with the modem.
3
Connect a USB cable (supplied with the modem) from one of the modems to server 1.
4 Connect the other modem, via USB cable, to server 2.
Separated servers
Each server has a dedicated telephone line.
1 Terminate the two 1MB telephone lines, one at each server, at RJ11 jack outlets.
2
Connect the modems to their respective server via a modular telephone cord supplied
with the modem.
3
Connect a USB cable (supplied with the modem) from the modem to the server at each
location.
NOTE:
For more information on media servers in 2 locations, refer to the job aid titled Server and
CSS Separation—Avaya™ S8700 Media Server .