Avaya G450 Manager, Справочное руководство CLI

Страница: 810 / 1334

CLI Commands PPP encapsulation
810 Avaya G450 CLI Reference
User Level
read-write
Context
general, interface:Serial (FR SUB)
Example
To create point to point sub-interface number 17 over channel group 2 over E1/T1 controller
number 1:
G450-001(super)# interface Serial 3/1:2.17 point-to-point
Related Commands
description (interface) , interface console , interface fastethernet , interface loopback , interface
tunnel , interface USB-modem , interface vlan , ip address , ip admin-state , ip broadcast-address ,
ip crypto-group , load-interval , show ip interface brief
encapsulation
Use the
encapsulation
command to set the encapsulation mode for a Serial interface. By
default, the Serial interface has PPP encapsulation. Use the
no
form of this command, which
has no parameters, to return to the default.
Use the
encapsulation frame-relay
option to create a frame-relay interface of the
IETF (RFC1490/RFC2427) type or non-IETF type. This command deletes the PPP interface
associated with the current Serial interface. The PPP interface cannot be deleted if at least one
IP interface is defined on it. Instead, the following message appears, “You cannot update this L2
interface since L3 interfaces are defined on it.”
By default, the Frame Relay encapsulation type for the main interface is IETF.
Note:
Note:
Non-IETF encapsulation is compatible with other vendors.
channel_group
For E1: 0-30
For T1: 0-23
sub_interface
1-127
ip_interface
0-1024
if_link_type
point-to-point
Parameter Description Possible
Values Default
Value