Avaya G150, Руководство по установке и настройке, Страница: 154 / 254

Configuring the G150 Media Gateway with Manager
154 Installation and Configuration of the G150 Media Gateway
The 4 analog trunks are viewed as one group by Communication Manager for ARS purposes
and should all be assigned the same incoming/outgoing line group ID.
●
Incoming Call Routing - Incoming call routes that are configured for G150 users should
also be configured on Manager. This is critical for routing incoming calls when the
connection between the G150 and Communication Manager is lost. Creating an incoming
call route via Manager is discussed later on in this section; see Create an Incoming Call
Route.
Remote Access
Before leaving the customer’s site, it is a good idea to set up remote access to the G150 system
for maintenance purposes. G150 provides Remote Access Server (RAS) functionality, allowing
external users to dial into the local area network from modems, terminal adaptors and routers.
Whether the remote connection is using an analog or digital line, the setup and use of the
remote access differs slightly.
To setup remote access, the following must be configured on Manager:
●
Change the password for the RemoteManager user account (default user for dial-in
access).
●
Use the RAS Dialin account.
●
Create an Incoming Call Route.
●
Create an IP route (optional).
To change the remote user password:
1. Click to receive a configuration form. The Receiving Config from dialog box appears
displaying the IP address of the G150. Enter the G150 system password.
2. Click User from the Configuration Tree. A list of users are displayed.
3. Double-click the RemoteManager user (default user for dial-in access).
4. On the User tab:
●
Extension: Leave blank
●
Password/Confirm Password: A default password is displayed, for security purposes,
enter a new password. Make note of this password in a secure location.
5. On the Dial In tab, ensure that the Dial In On option is enabled/ticked.
6. Click OK.
7. If this is the last configuration being performed on Manager, click Save. In the Sending
Config To dialog box, accept the selected save option and click OK. Otherwise, continue
making additional configuration updates and perform a Save when ready.