Avaya Definity SI, Руководство по обслуживанию, Страница: 2466 / 2968

Maintenance Object Repair Procedures
555-233-123 10-1680 Issue 4 May 2002
Table 10-618. TEST #1242 Level 1 Status Inquiry
Error
Code Test
Result Description/Recommendation
1187 ABORT The board or port may be busied out.
1. Look in the Error Log for Error Type 18 (port busied out)
for this port and TBRI-BD (board busied out). If this error
type is present for TBRI-PT only, then release the port
with the release port PCSSpp command and run the
test again. If the error is present for both TBRI-BD and
TBRI-PT, then release the board with the release board
PCSS command and run the test again.
NOTE:
When you release a port, you release all ports
associated with it. If certain ports still need to be busied
out, use the release port PCSSpp command to busy
them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5
times.
2000 ABORT Response to the test was not received from the circuit pack
within the allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset
the circuit pack with the busyout board PCSS and reset
board PCSS commands.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page